Ultrak JPD-101, User Manual

Page: 57 / 144

MONITOR SEQUENCING
518007-3960-F 2-39 KEMU040019
April 25, 2001
2.2.10 Monitor Sequencing (1-32).
Monitor sequences only apply to systems with a CATS Video Switcher
installed. A sequence can be programmed and stored in the CATS Video
Switcher for each video output (monitor). A monitor can be programmed to
sequence continually between the desired cameras (up to 32) for up to 30
seconds each. Sequences can be programmed, started/stopped, and
deleted using the JPD-101 Controllers. Refer to Section 3, paragraph 3.3.
The SEQ key on the controller is used to program, start/stop and delete
monitor sequences. Refer to Section 3 for programming procedures.
START/STOP SEQUENCE
Enter the following commands on a JPD-101 to start a sequence on a video
output (monitor). The sequence runs continuously until the operator stops it.
The same command toggles between the start and stop functions. The
commands are in bold typeface separated with the symbol >.
SEQ> Monitor #> ENTER> 1 SEQ # ENTER 1
Example:
Start a sequence on monitor 2.
SEQ>
CNTL - CAM 1 MON 1
Seq. Mon. NO. __