ULTRAFRYER Systems PAR-3-HE, Operating Instructions Manual

Page: 21 / 65

30A135
b. TO TEST OPERATE a Ultrafryer Gas Fryer equipped with an Ultrastat 11 Cooking Computer:
1) Ensure the fryer’s Toggle ON/OFF Switch is in the OFF position.
2) Fill the fryer vat with hot or cold water to the middle of the “E” in the word LEVEL of the shortening level mark on
the rear of the vat.
3) Turn the MANUAL gas valve to the
OFF position and wait FIVE (5) minutes for any accumulated gas to disperse.
4) ENSURE the MAIN gas shut-off valve is in the ON position, and that the Vent Hood EXHAUST FAN is ON .
5) Turn the MANUAL GAS VALVE to the ON position.
6) Perform the following steps, in the order listed:
STEP ACTION RESPONSE
1
ENSURE the drain valve is in the closed posi-
tion and that water is at the proper level; then
turn the Toggle ON/OFF switch to the
ON
position and turn the Ultrastat 11 Cooking
Computer
ON
by depressing the
ON/OFF
key.
A. The AMBER power lamp beside the fryer Toggle
ON/OFF switch will LIGHT.
B. CY P will appear in the Ultrastat 11 Computer display
to indicate it is in the
PURGE MELT MODE.
C. The Computer will begin cycling the gas burner
ON and OFF .
CAUTION: PRIOR TO PROCEEDING TO STEP 2, VISUALLY CHECK THAT THE HEAT EXCHANGERS TUBES ARE
COVERED BY AT LEAST 2” (51 mm) OF WATER.
2
When the water begins to BOIL, depress the
EXIT MELT key.
HEAt
will appear in the computer display to
indicate it is in the
FULL ON
mode.
3 Depress the TEMP key ONCE.
The
ACTUAL
water temperature will be shown
in the computer display
4
Turn the Ultrastat 11
OFF
by depressing and
holding the
ON/OFF
key for
3 SECONDS,
then turn the fryer
TOGGLE ON/OFF
switch
to the OFF position
The
AMBER POWER
lamp beside the fryer
TOGGLE ON/OFF
switch will turn
OFF.
5
After the water in the vat and metal surfaces of
the fryer has
COOLED
, drain the water into a
floor drain.
c. TO TEST OPERATE a Ultrafryer Gas Fryer equipped with an Ultrastat 21 Cooking Computer, use the procedures con-
tained in the Ultrastat 21 Gas Fryer Computer Operation Instructions PN 30A009, provided with the fryer.
d. TO TEST OPERATE a Ultrafryer Gas Fryer equipped with an Ultrastat 25 Cooking Computer, use the procedures con-
tained in the Ultrastat 25 Gas Fryer Computer Operation Instructions PN 30A051, provided with the fryer.
G. INITIAL CLEANING - New MODEL PAR-3-HE gas fryers are wiped clean at the factory to remove any visible signs of dirt,
oil, grease, etc., remaining from the manufacturing process. Each fryer and filter system should be THOROUGHLY washed
with HOT sanitizer solution to remove film residues, installation dust or debris and then wiped dry prior to placing the fryer
in operation.
Vat Shortening
Return Lever
(shown Closed)
Topside Shortening
Return Lever
(shown Open)
Drain Valve
Page 17 of 61