UINICS CU-675 Series, Operation Manual

Page: 27 / 44

- 24 -
Mode No. Setting of termination signal of output timing and output width
Ｐ－０４
Ａ Ｂ Ｃ Ｄ Ｅ Ｆ
Ｐ － ０ ４
Ｇ Ｈ Ｉ Ｊ Ｋ Ｌ
０．５ ０．１
Output width
0.1～9.9 sec（0.0 holds an output.）
Output timing
0.0～9.9 sec
〔Output timing〕
It is set up in how many seconds an end signal is outputted,
after a measurement value reaches a desired value
(after a control signal is canceled）.（ｔ１）
〔Output width〕
The output width time (t2) of an end signal is set up.
When output maintenance (0.0) is set up, it cancels by start signal
(or switch) ON.
ｔ１＝Output timing ／ ｔ２＝Output width
＜The example of a setting＞
For 1 second wants to output an end signal., after 2 seconds of since a
measurement value reaches a desired value.
Ａ Ｂ Ｃ Ｄ Ｅ Ｆ
Ｐ － ０ ４ Ｈ．Ｉ：２．０（After 2 seconds）
Ｇ Ｈ Ｉ Ｊ Ｋ Ｌ
２．０ １．０ Ｋ．Ｌ：１．０（The output during 1 second）
＜Caution＞
The end of measurement operation serves as a time of the output of an end
signal finishing.