UINICS CU-675 Series, Operation Manual

Page: 40 / 44

- 37 -
２．Status
① The view of status
Status has written the hexadecimal number by 2 bytes of character string.
② Status allotment
００ Normal communication.
０１ Communication fault.
３．Communication format Table.７
Measurement data lead
（TOTAL）
Command format ＠××ＲＤ１△△CR
Response format ＠××◇◇±□□□□□□△△CR
Measurement data lead
（ＰＶ）
Command format ＠××ＲＤ２△△CR
Response format ＠××◇◇±□□□□□□△△CR
Measurement data lead
（Analog input）
Command format ＠××ＲＤ３△△CR
Response format ＠××◇◇±００□□□□△△CR
SV value lead
Command format ＠××ＲＰ１△△CR
Response format ＠××◇◇±□□□□□□△△CR
Deviation error (analog
input) upper limit val
ue lead
Command format ＠××ＲＰ２△△CR
Response format ＠××◇◇±００□□□□△△CR
Deviation error (analo
g input) lower limit va
lue lead
Command format ＠××ＲＰ３△△CR
Response format ＠××◇◇±００□□□□△CR
SV value write(*1)
Command format ＠××ＷＰ１±□□□□□□△△CR
Response format ＠××◇◇△△CR
Deviation error (anal
og input) upper limit v
alue write (*1)
Command format ＠××ＷＰ２±００□□□□△△CR
Response format ＠××◇◇△△CR
Deviation error (anal
og input) lower limit v
alue write (*1)
Command format ＠××ＷＰ３±００□□□□△△CR
Response format ＠××◇◇△△CR
（*１）This data light command can be used when 2 or 3 (RS-232, RS-485) setup of J in the
mode P-00 is set up.
××・・・・・ＩＤ No.
△△・・・・・Checksum
◇◇・・・・・Status
□□□□・・・Indicated value data
Please keep in mind that a decimal point does not go into transmission and received data.
A decimal point position turns into a position according to each display.