UINICS CU-675 Series, Operation Manual

Page: 6 / 44

- 3 -
S
I
G
N
A
L
o
u
t
p
u
t
Control signal
From the start signal output、to the PV display value (measured value)
reaches the SV value(target value).In the output, control signal
display (RUN), lamp lighting.
Output
method
Relay 1c contact output
AC250V（DC30V）5A MAX（Resistance load）
Deceleration signal
Two-stage opening and closing or Deceleration mode switching
Two-stage opening and closing：From the Start time to the
preset value that is to OFF, the output was stop before
preset of the SV value(target value).
Deceleration：The value output from the front set of SV,
until it reaches the value of SV.
Output
method
Relay 1c contact output
AC250V（DC30V）5A MAX（Resistance load）
End signal
Output when the PVdisplay value（measured value）reaches the
SV value(target value).
Retention or One-shot output：Output width Can be set between
0.1 to 9.9 seconds. In the output,Termination signal-display
（END）,lamp lighting.
Output
method
Relay 1a Contact output
AC250V（DC30V）3A MAX（Resistance load）
Signal input anomaly
detection
Abnormal measurement、Abnormal deviation、Output when the
Abnormal signal.
Abnormal measurement and When the Measurement signal for
ON Measurement error display（ALM）Lamp lighting.
When the Abnormal deviation was Deviation error display（STS）
Lamp lighting.
Output
method
Relay 1a Contact output
AC250V（DC30V）3A MAX（Resistance load）
Synchronization pulse
signal
Total output in synchronization with the display.
Select a digit 1-6 digit synchronous output.
Choose one of the seconds 10ms, 100ms, 1s output width.
Output
method
NPN open collector output DC30V 50mA MAX
O
t
h
e
r
Power failure compensation FRAM Data Backup About 10 years
Power AC85～264V 50／60Hz
Power consumption About below 19VA
Humidity/Temperature 0～50℃ 30～85％RH（Without condensation）
Mass About 850ｇ
Physical dimensions W72×H144×D122mm（Dimensions include terminal cover）
Degree of protection IP66
Case material Body iron case Front part ABS