UINICS CU-675 Series, Operation Manual

Page: 10 / 44

- 7 -
5．Connecting terminal boards
≪ Terminal block connection diagram ≫
Fig.4
A．3-wire type pulse sensor Fig.5 B．2-wire type pulse sensor Fig.6
① Sensor input
Please connect to the terminal block 1, 2, 3.
② Reset signal
When the reset signal was ON、the PV measurement value return to”0”.
Also、abnormal output release too.（It is the same as the reset key on the front panel.）
Please connect to the terminal block 3, 4.
Note： Reset in the batch control, will can not be a successful batch control.
③ Stop signal
When the stop signal was ON in the batch control, stop the batch control.
Release the control, deceleration signal.End signal is not output.
During the stop, it will remove the measurement abnormal signal.（It is the same behavior
as the stop key on the front panel）
Please connect to the terminal block 6, 7.