33
CHARGING THE BATTERY
It is important that the battery is charged on a regular basis. The instrument constantly powers the inter-
nal sensors and may discharge the battery if left unattended for serveral months. Connect the charger
supplied with the instrument to the correct mains supply.
Note:
The correct charger type may be required for your local voltage i.e. 110 or 220volts AC.
Insert the plug in the socket marked CHARGER INPUT SOCKET
The CHARGER ON RED LED will flash showing the instrument is charging.
CHANGING THE PAPER ROLL
To change the paper roll, remove the printer cover by loosening the two screws holding it down. Remove
the old paper roll core and insert the new roll so that it sits as follows:
Feed the free end of paper into the printer through the metal slot beneath the printer ribbon. Start the
paper feed sequence until the paper has emerged from the top of the printer, feed the loose end through
the cover and refit.
TO START PAPER FEED
Go to MENU, REPORTS, FORM FEED
CHANGING THE PRINTER RIBBON
The printer ribbon cartridge will last for approximately two rolls of paper. Remove the printer cover as
detailed above.
Marked on one end of the cartridge is PUSH. Gently press down on this end and the ribbon cartridge will
pop up at the other end. Remove the cartridge and dispose of.
Summary of Contents for K9206
Page 29: ...29 ...
