http://u-prox.com
30
Maintenance
Factory reset (before installation)
To return panel to the factory settings, perform the following steps:
1.
De-power the panel
2.
Remove top cover of panel
3.
Short D1 (white) and D0 (green) wires
4.
Power up
5.
Wait for six beeps, signaling the successful panel reset
6.
Disconnect panel
7.
Remove short from D1 (white) and D0 (green) wires
Factory reset (after installation)
To return panel to the factory settings, perform the following steps:
1.
Do not turn off the power. Remove top cover of panel
2.
Connect the notebook running 'Configurator' program with USB cable to the
panel
3.
Connect to panel using software “Configurator"
4.
Set the parameter "test period" equal to 0 (zero)
5.
Upload (write) the new configuration to the panel
The controller will restart with factory settings
Switching to programming mode
To put panel in programming mode do the following:
1.
Do not turn off the power. Remove top cover of panel
2.
Connect to USB cable and set up the device using
software “Configurator"
Replacing the device firmware
1.
De-power the panel
2.
Remove the top cover of panel
3.
Connect the notebook with USB cable to the panel
4.
Using special software, do the replacement of panel firmware
5.
After downloading the firmware to the panel WAIT for SIX SHORT SIGNALS. It
is the signal of correct firmware loading.
Factory settings
Communicatior
Ethernet mode enabled, DHCP enabled (no device IP set), no ACS server set
Inputs
Z1, Z2, Z3(RTE)
– disabled
Outputs
Relay 1 is disabled
Readers
Internal
– RS mode, full RF ID (42Bit), External - RS mode, full RF ID (42Bit)
