http://u-prox.com
20
How to work with the device
The panel is delivered in a small plastic
case with subsequent sealing Overall
dimensions are shown in Fig. 11.
Connection procedure
1.
Before installation do initial setup
of panel (that specifies settings
of network parameters) with
utility "Configurator" via USB
Port
2.
In the place of installation of the
panel do preparing - mark and
drill the holes (see Installing
panel)
3.
Run the cable lead from the power
supply
4.
Run the cable lead from the actuator
(lock)
5.
Install external reader and run their cables (if necessary)
6.
Run loops from sensors / buttons
7.
Run the cable lead-Ethernet (if necessary)
8.
Run the wire commutation of power supply, lock, reader, inputs of the panel
with the loops in accordance with the sections below (recommended using
the back box)
9.
Perform installation of the Ethernet cable into the connector terminal blocks
10.
Place the installation cables into the wall
11.
Fit the back plate of the panel, plug panel into the back plate, put the top
cover and secure with the screw.
12.
Connect the panel to ACS (in accordance with the instructions ACS)
13.
By means of ACS, perform full panel adjustment (set of inputs, outputs,
schedules, RF IDs, etc.).
14.
Ready for operating
When the panel is in stand-alone
mode, paragraphs 11 and 12
should
be
performed
before
paragraph 2.
Figure 11
. Overall dimensions
