http://u-prox.com
29
Panel programing
Software
Operation
1. Determination of panel operation mode: standalone or as
part of ACS
Software
"Configurator"
connection
through the USB
port
2. Setting initial parameters: network settings of panel:
a.
Type of device - Wi-Fi or Ethernet
b.
Wi-Fi key of access to the network and encryption
type (repeat when multiple networks)
c.
Server settings: IP address or DNS name of the
server, access ports (port to read, port to write)
Don't proceed paragraph d. if DHCP used in the network.
d.
Device Settings: IP address of the device in computer
network, subnet mask, IP DNS server, gateway to the
Internet
ACS
software
3. Panel enrollment and activation in the access control
system software (refer to the software manual)
4. Set up device with ACS software
a.
Door settings: Single-sided or Double-sided door,
operation of Antipassback, Time of PIN entering (or off)
b.
Access points settings: no. of readers, Door Times,
"Alarm
Prohibited.
Door
forced
open",
"Alarm
Prohibited. Door opened too long" attributes
c.
Readers settings: reader type of 26 or 42 bit
d.
Panel inputs settings: type of reaction and access point
(e.g., door sensor, access point of A and B, or a free
pass, access point B).
e.
Panel outputs settings: type of use (lock, siren, etc.),
operating mode, the pulse duration (if available in this
mode), access point that operates this output.
5. ACS software creates the list of RF IDS with their attributes,
schedules and access rights based on personnel access
politics programmed in the system (Refer to the ACS software
manual).
6. After forming and loading the configuration from ACS
software the panel is ready for use.
