KANGAROO
e
Pump
™
Enteral Feeding Pump
Hold
Pump operation can be paused by pressing
4
HolD
while it is
RUNNING
, such as in Figure 15A. The status line will indicate
HOLDING and the yellow LED indicator will be lit up to give a quick visual indication of an informational status in a darkened room.
Note: the pump’s alarm will sound if it has been left
HOLDING
for 10 minutes without further input.
There are five options available during
HOLDING
. See Figures 18A and 18B
.
figure a.
HOLDING
mode
options, continuous feeding mode.
figure b.
HOLDING
mode
options, intermittent feeding mode.
Clear Volume fed
Press
4
CleaR VolUMe
to re-zero the output feed totals “
ml feD
,” “
bolUses feD
,” and “
ml flUsH
.”
adjust settings
Press
4
aDJUsT seTTInGs
to return to one of the opening menus shown in Figures 7A-7D, thus allowing any setting to be modified.
If the Pump Set has been removed after going into
HolD
, the opening menu will show
LOAD A SET
, as seen in Figures 5A-5B
.
ResUMe In __ MIn
(Not Available in EZMODE)
Press “
ResUMe In __ MIn
” once to immediately place the KANGAROO ePump into a 30-minute resume running mode. Pressing the
ResUMe In __ MIn
button again will cycle the “resume in” time back to zero. No other input is needed to start the countdown, as
the time immediately counts down after the 30 minute value is reached.
Run Mode
Press
4
RUn
to immediately restart pump operation. This option will not be available if the Pump Set is removed during
HolD
.
View History
(Not Available in EZMODE)
Press
4
HIsToRy
to access the
HISTORY
screen. Use this screen to review feeding and flushing history. See subsection “More
Options” below for further information.
