KANGAROO
e
Pump
™
Enteral Feeding Pump
figure b.
battery setup
The battery pack is fully charged before shipping, and is left unconnected to optimally preserve battery life.
WaRnInG:
The battery should be connected before using the pump.
It is also recommended that the battery charge be “topped off” before battery-only operation is utilized. The battery pack will charge
continuously whenever the pump is plugged into a wall outlet, including during normal use of the pump with A/C power. Eight
hours of charging is required to fully recharge the battery pack.
A new battery pack will provide approximately 15 hours of service before needing to be recharged.
attaching Pole Clamp
The KANGAROO ePump enteral feeding pump can be attached to a vertical pole using the Pole Clamp, included with the pump. The
pole clamp provides the ability to retain the power cord to prevent accidental cord removal or cord loss. Simply place the power
cord into the U-shaped groove located on the back of the pole clamp as shown in Fig. 3 and attach the pole clamp to the KANGAROO
ePump enteral feeding pump. Be sure not to pinch the power cord or damage the cord insulation when installing.
To attach the Pole Clamp to the KANGAROO ePump enteral feeding pump, align the hole on the Pole Clamp with the mounting hole
on the back of the pump. Use a 3/8” - 16 bolt to fasten together, as shown in Figure 3
.
