3. Programming
D-306488 WK250 Installer’s Guide
25
– Changing Defaults
[1]
Enter the
Installer Menu
, select the "02.ZONES/DEVICES"
option (see section 3.2) and then select the
"
DEFINE DEFAULTS
"
option.
[2]
Select the respective Group of the device you wish to define its defaults. For example, "
MOTION
SENSORS
".
[3]
Scroll the parameter list of the Device Group and select the Default Parameter you wish to change, for
example: "
EVENT COUNTER
". The list combines the parameters of all devices in the group, for example, the
parameters of all types of Motion sensors.
[4]
In the example, the existing default setting of the "Event Counter" for enrolled motion sensors was "
low
"
sensitivity (marked with
) . To change it to "
high
", scroll the menu until the display shows "
high
" and press
the
button. The new default for the Event Counter parameter setting of Motion Sensors enrolled from
now on will be "
high
".
[5]
The new default does not affect motions sensors that were already enrolled before the change was made but
only new motion sensors that will be enrolled in the alarm system after the change is performed.
3.4.8 Updating Devices after Exiting Installer Mode
When exiting the "
Installer mode
", the WP panel communicates with all devices in the system and updates them with
the changes that have been performed in their "Device Settings" configuration. During the updating period, the WK250
display indicates "
DEV UPDATING 018
" where the number (for example, 018) is a countdown of the remaining number
of devices yet to be updated.
3.4.9 WK250 Display when WP Panel is Active
When a WP panel is 'ACTIVE', meaning that the WP panel is currently in the USER SETTINGS / PERIODIC TEST /
INSTALLER MODE / LIST OF EVENTS menu, the following text appears on the WK250 display:
BUSY
CP IS ACTIVE
1
Refers to WP8010/WP8030 only