Air Tools TERMI-POINT
(diverse types)
©2013 Tyco Electronics AMP GmbH, a TE Connectivity company.
All rights reserved.
TE Connectivity, TE connectivity (logo), TERMI-POINT and Tyco
Electronics are Trademarks.
57/ 64
Customer Manual
412-18008 Rev. D1
* Other products, logos and company names mentioned herein may be trademarks of their respective owners
15.3.1.2 Tool Qualification Test
A periodic tool qualification test should be made to make certain that tool no. 69358 maintains the proper
calibration. Use the following procedure to check tool calibration:
1.
Connect TERMI-POINT test tool to an accurate mechanical force gage.
A typical setup using a Hunter L 5 M force gage and adapter is shown in Fig. 31.
2.
Force gage and test tool must be held in a horizontal plane and be aligned when making the
test.
Be careful to prevent binding between shaft and end of test tool (Fig. 31).
Fig. 31: Tensile Test
1
Hunter L-5-M Federwaage oder
Äquivalent
4
Schaft
2
Zugstrecke 13mm / sec.
5
Anzeigering
3
Adapter (nicht im Lieferumfang)
3.
Pull tool while using a rate of 0,5 inches per second.
4.
Gradually decrease pull rate until indicator ring is in line with front of tool. Check gage reading.
5.
If gage reading is not satisfactory, test tool should be returned to Tyco Electronics AMP
GmbH.
Post size
Test force
Indicator
ring color
Pin
Part No..
Clip
Part No.
Test-Tip
Part No
[mm]
[N]
0,8 x 1,6
11
gelb
69358-2
X-330 495-X
69544-1
0,8 x 2,4
X-330 854-X
NOTE
Gage must be set in “Lock” position to record maximum reading !
