Air Tools TERMI-POINT
(diverse types)
©2013 Tyco Electronics AMP GmbH, a TE Connectivity company.
All rights reserved.
TE Connectivity, TE connectivity (logo), TERMI-POINT and Tyco
Electronics are Trademarks.
35/ 64
Customer Manual
412-18008 Rev. D1
* Other products, logos and company names mentioned herein may be trademarks of their respective owners
Perform the following steps as specified in each paragraph to prepare the tool for repair and/or part replace-
ment.
13.1 Push Rod and Saddle Spring Replacement
1.
Remove screws from side cover (2) and remove side cover; use care not to lose spring (39)!
2.
Remove four screws (39) holding top cover to tool.
3.
Remove push rod from its drive pins (27).
4.
Saddle spring (36) may now be replaced, if necessary you can also exchange the push rod.
5.
Perform steps 4 thru 1 in reverse order.
13.2 Clip Guide Anvil Replacement
When clips jam on rear area of clip guide anvil, the clip guide anvil may be worn or broken.
1.
Perform steps 1 thru 5 as described in section. 13.1”Push Rod and Saddle Spring Replace-
ment.
2.
Remove the right post pickup (25) by lifting it from its pin; use care not to damage the tubing.
3.
Break clip train at a convenient point feeding back the rest into reel. Carefully remove jammed
clips from clip guide anvil.
4.
Remove screws (7; 8), tooling foot (28) and attachment key (9).
5.
Remove the complete block (Fig. 19) containing left and right guide plates (4; 5).
Fig. 19: Clip Guide Anvil Replacement
1
Block
3
Screw (item 7)
2
Rear of clip guide anvil 4
Screw (item 8)
WARNING
Risk Of Injury!
Risk of starting up!
Separate the tool from the compressed air supply, if you have
to do some adjustment work on the tool.
