Air Tools TERMI-POINT
(diverse types)
©2013 Tyco Electronics AMP GmbH, a TE Connectivity company.
All rights reserved.
TE Connectivity, TE connectivity (logo), TERMI-POINT and Tyco
Electronics are Trademarks.
20/ 64
Customer Manual
412-18008 Rev. D1
* Other products, logos and company names mentioned herein may be trademarks of their respective owners
6.1
Tool Preparation
Fig. 7: Tool Preparation
1
Top cover holding screws
6
Wire funnel lever
2
Top cover
7
Triggerr
3
Mandrel
8
Wire cutter
4
Tooling foot
9
Balancer mounting
5
Mandrel holding screw
10
Screw
1.
Hold tool securely with index finger positioned over trigger. Become familiar with weight and
feel of tool, while practicing aiming movement.
2.
Place index finger on wire funnel lever (directly above trigger, Fig. 7) and operate wire funnel
lever several times. Note that as lever is pulled, wire funnel on top of tool (Fig. 7) moves back
and, as lever is released, wire funnel moves forward. In operation, this permits wire to be
properly positioned in tool and clamped in place for termination cycle.
3.
With clips loaded (Fig. 8) and mandrel installed Fig. 7), connect tool to air supply and regard
all applications in section 3 „General safety instructions“.
Fig. 8: Clip Level
