Air Tools TERMI-POINT
(diverse types)
©2013 Tyco Electronics AMP GmbH, a TE Connectivity company.
All rights reserved.
TE Connectivity, TE connectivity (logo), TERMI-POINT and Tyco
Electronics are Trademarks.
23/ 64
Customer Manual
412-18008 Rev. D1
* Other products, logos and company names mentioned herein may be trademarks of their respective owners
6.3
Unloading the Tool
1.
Break clip train at a convenient point between tool top cover and reel bracket.
2.
With air supply connected, operate tool by squeezing trigger to advance clip train and contin-
ue until tool is unloaded (no more clips are transported).
3.
Squeeze spindle of reel holder, insert fingers through holes provided in back of reel holder
and push reel out.
6.4
Installation of Mandrel
1.
Disconnect tool from factory air supply.
2.
Select correct mandrel for wire size and clips being used. Check GP 1935 1935
(section.5.2.2 “Per GP 1935 Rev. Germany 3/86“) for tool and clip selection and GP 1944
(section.5.2.3 “Per GP 1944 Rev. Germany 3/86“) for component color code data to ensure
that mandrel, clips and wire size being used are compatible
3.
Remove mandrel holding screw (ref. Fig. 7) and loosen screw (10).
4.
Remove tooling foot (4).
5.
Open both post pickups and insert mandrel; align hole in mandrel with mandrel holding screw
hole!
6.
Re-install tooling foot.
7.
Release post pickups, insert and tighten mandrel holding shoulder screw (10).
6.5
Removal of Mandrel
1.
Disconnect tool form factory air supply.
2.
Remove mandrel holding shoulder screw (ref. Fig. 7) and screw (10).
3.
Remove tooling foot (4).
4.
Open both post pickups, grasp front of mandrel and carefully pull mandrel out of tool.
5.
Release post pickups and insert mandrel holding shoulder screw, do not tighten it.
Fix screw (10).
NOTE
Use care not to push against stripping ear area of mandrel so as not to dam-
age cutting edge of mandrel!
NOTE
Use care not to push against stripping ear area of mandrel; doing so may
damage cutting edge of mandrel!
