Air Tools TERMI-POINT
(diverse types)
©2013 Tyco Electronics AMP GmbH, a TE Connectivity company.
All rights reserved.
TE Connectivity, TE connectivity (logo), TERMI-POINT and Tyco
Electronics are Trademarks.
55/ 64
Customer Manual
412-18008 Rev. D1
* Other products, logos and company names mentioned herein may be trademarks of their respective owners
15.2.1.3 Process Requalification
The process should be requalified in accordance with section 1 whenever one of the following conditions
occurs:
1.
Application tool has been cycled 100.000 times.
2.
Application tool parts like mandrel, pushrod assembly have been replaced or larger repairs
have been taken place.
15.3 Pull Test Tool Part-No. 69358-2
Part No 69 544-1 (per IS 1933, Rev. Germany 3/86)
15.3.1 Introduction
The Pull Test Tools, Part No. 69358-2 as well as Test Tip 69544-1 are used to make non-destructive tests of
the termination´s mechanical quality.
15.3.1.1 Testing Procedure
1.
Pull Test Tool, Part. No. 69358-2
a.
Hook tool squarley against end of Clip with tip engaging end of curls on clip (Fig. 29)
Fig. 29: Tool Qualification Test
1
Hunter L-10-M mechanical
force gage
5
Clip
2
Thread Tipp onto gage
6
Wire
3
Test tip
7
Top of tool engages ends of curls
on clip
4
Post
8
Indicator ring
