71
Display Aspect Ratio
- This allows you to change the Aspect Ratio of the outgoing
signal on the Output of Monitor module. Click on the dropdown menu and select the
required Aspect Ratio. Click on ‘
OK
’ at the bottom of the Output Settings window and the
new Aspect Ratio will be implemented.
Display Aspect Ratio
– Because set resolutions change the way the Video signals are
handled, this feature allows you to lock the Aspect Ratio irrespective of the Output
resolution that has been set.
Display Type
-
This feature is disabled in this version of Firmware.
HDCP Downstream
- This feature is disabled in this version of Firmware.
Output Type
– This feature allows you to change the connectivity configuration of the
DVI-U Output. Because DVI-U has the capability of supporting different connection
formats, the Monitor module utilises different pin configurations to match the display
devices physical connectivity and sync. It is important to select the correct configuration
to match the display device as improper connectivity may lead to loss of video. The
options are RGBHV (analog and digital), RGBS, RGsB and YUV.
The default Output Type is ‘
RGBHV
’. In this mode it will work with DVI-D, DVI-A, HDMI,
analog RGB\VGA and CV+YC signals.
In some HDMI systems YUV Colour Space is required. Click on the drop-down menu,
select ‘
YUV
’ then press ‘
OK
’ on the Output Settings window. This will also set the
activate analog YUV for YPbPr applications.
HDMI Found
– ‘
Found
’ is shown when an HDMI display has been connected and
acknowledged, ‘
Not_Found
’ is shown when the display is disconnected or not
compatible. This may be particularly useful when troubleshooting a system setup where
the display device is remote to the C3-340 via signal transmission equipment
