WWW.TURNSTYLEGATES.COM
Foreign & Domestic Patents Issued & Pending
!
1-800-548-2212
11
e.
Allow concrete to cure
Support the Turnstyle operator if necessary, until the concrete sets sufficiently to
hold the operator and ground sleeve plumb or loosen the collar clamp on the
ground sleeve and slide the inner steel tube of the operator out of the ground
sleeve and allow the concrete to cure.
Once concrete is set and ground sleeve(s) is/are secure, replace the Turnstyle
operator(s) into the ground sleeve(s) if they were removed during concrete curing.
Step 2:
Attach the gate mounting brackets and gate onto
the Turnstyle Operator.
If your gate has been integrated with your Turnstyle operator, you will not need to attach gate
mounting brackets. In this case, your gate will already be integrated (welded) with the Turnstyle
operator. See page 5 for further instructions.
See page 12 for instructions on attaching your brackets and gate to your
Turnstyle operator.
At this point you have successfully installed a Ground Mount single gate
manual Turnstyle GMS™
If you are installing an automatic Turnstyle GMS™, proceed to page 14 to find
the electronics installations instructions.
Step 1:
Install the opposite ground sleeve and Turnstyle ground mount
operator
Return to page 10 and follow Ground Mount installation instructions from
Step 1:
a.
Determine location of your Turnstyle Ground mount GMS™
through
Step 1:
c. Prepare concrete
and then proceed below.
a.
Using a string level, stretch a string from the top of the previously
installed ground sleeve to the top of the opposite ground sleeve.
Adjust the ground sleeve as needed (back filling if necessary,) until the string is level
and the ground sleeve is in its desired location.
Return to page 10 and follow Ground Mount installation instructions from
Step 1:
d.
Level Turnstyle operator and secure ground sleeve into
ground
through
Step 2:
Attach the gate mounting brackets and gate onto
the Turnstyle Operator.
At this point you have successfully installed a Ground Mount dual gate
manual Turnstyle GMS
™
If you are installing an automatic Turnstyle GMS™, proceed to page 14 to find
the electronics installations instructions.
Step By Step:
How to Install the opposite operator for a
Turnstyle Ground Mount Dual Gate Mounting System (GMS)™
a. Removing the Turnstyle operator from the ground sleeve while allowing
the concrete to cure will reduce external forces on the ground sleeve.
b. Cover the ground sleeve while allowing the concrete to cure to avoid debris
from entering the ground sleeve.
c. Allow the concrete to cure according to the concrete manufacturer’s guidelines.
d. Leave the collar clamp on the ground sleeve loose for manual operation.
