Safety notes
Page
2-6
Coupling and uncoupling the accessory
•
Always couple and transport the attachment using a suitable carrier vehicle!
•
Couple the attachment to the specified equipment according to the instructions!
•
Make sure that the following values are not exceeded by coupling the attachment to the frontal
attachment of the machine:
ο
the permitted gross weight of the machine,
ο
the permitted axle loads of the machine,
ο
the permitted support loads at the machine's connecting points,
ο
the permitted towing capacity of the connecting device,
ο
the permitted tyre load of the machine.
•
Safeguard the machine and attachment from rolling away before coupling or uncoupling the
attachment!
•
Persons must not be standing between the machine and attachment while the machine is moving
towards the attachment!
Assistants who are present may only act as guides next to the vehicles and may only move
between the vehicles when they are at a standstill.
•
Move the required support devices into the respective support position (stability) when coupling
and uncoupling the attachment!
•
Risk of crushing and shearing when operating the support devices!
•
Be particularly careful when coupling to and uncoupling from the machine! There are crushing
and shearing points in the vicinity of the coupling points between the machine and the
attachment!
•
Persons must not be standing between the machine and attachment when the three-point
hydraulics are operated!
•
Monitor the coupled supply lines. Coupled supply lines:
ο
must give way slightly when driving around corners without tension, kinking or friction,
ο
must not chafe against external components!
•
Always place the uncoupled attachment in such a way that it is stable!
Use of the attachment
•
Before starting work, familiarise yourself with all of the equipment and operating elements of the
attachment, including the functionality thereof. There is no time for this once work has started!
•
Wear closely fitting clothes! Loose fitting clothing increases the risk of grabbing or entanglement
in the drive shafts!
•
Only start up the attachment if all safety equipment is attached and in the protection position!
•
Pay attention to the maximum load of the attachment and the permitted axle and support loads of
the machine! If necessary, only drive with the load compartment partially filled!
•
Persons must not be present:
ο
in the working / hazard area of the attachment,
ο
in the discharge area of the attachment,
ο
in the rotating and swivelling area of the moving parts of the attachment,
Summary of Contents for Snow blade SF
