Coupling and uncoupling of the attachment
Page
4-13
Mechanical side adjustment
•
Pull the spring plug (2) and adjustment bolt (3) out of
the outer part (1).
•
Swivel the SF snow blade 30°.
•
In the outer part (1) and inner part (4), secure the
position with the adjustment bolt (3) and spring plug
(2).
If the snow blade hits the carrier vehicle at
an angle of 30°, the inner part (4) must be
turned.
Changing the angle from 30° to 25°
•
Dismount the cylinder limit stop bolt (5).
•
Convert the inner part (4), threaded joint (7) and
threaded bolt (6) as described in steps 1 to 4.
•
Mount and secure the cylinder limit stop bolt (5).
The SF snow blade now only swivels 25°.
•
Secure the angular setting with the adjustment bolt (2)
and spring plug (1).
.
Fig.4.21
4.5.2
Hydraulic side adjustment
The safety instructions from Chapter 4.2 apply
o
Danger of getting squashed!
When hydraulically swivelling the snow blade, no persons may be
present between the snow blade and the carrier vehicle
Perform hydraulic side adjustments only
while the carrier vehicle is at a standstill.
•
Actuate both pitch control cylinders (1) with the
appropriate control lever in the carrier vehicle.
.
Fig.4.22
NOTE
NOTE
ATTENTION
Summary of Contents for Snow blade SF
