Tuchel Snow blade SF, Operating Manual, Page: 48 / 59

Cleaning, servicing and maintenance
Page
6-2
6.1 Cleaning
•
Clean the attachment regularly and thoroughly. Dirt attracts
moisture and leads to the build up of rust.
•
Lubricate the attachment after cleaning. Avoid moisture when
cleaning, blowing off is normally sufficient.
•
Pay attention to the legal regulations for handling and removing
the cleaning agents.
•
Repair any paint damage if necessary.
•
Monitor the hydraulic lines extremely carefully!
•
Never treat the hydraulic lines with petrol, benzene, petroleum or
mineral oil.
•
If the attachment cannot be used over a long period of time, the
attachment must be lubricated after cleaning, sprayed with oil
and the piston rods of the hydraulic cylinder greased.
Cleaning with a high-pressure cleaner / stream jet
Always observe the following points if a high-pressure cleaner /
stream jet is used for cleaning:
•
Never direct the cleaning jet of the cleaning nozzle of the high-
pressure cleaner / stream jet onto lubricating and bearing points.
•
Always maintain a minimum distance of 300 mm between the
high-pressure cleaner and stream jet cleaning nozzle and the
attachment.
•
Observe the safety regulations when handling high-pressure
cleaners.
6.2 Replacing the scraper bars
•
Change the scraper blade only while the snow blade is attached.
•
Only perform work on the snow blade with the engine switched
off and the hydraulics depressurised. Pull the ignition key and
secure the carrier vehicle against unintended start-up and
movement.
•
Secure the snow blade against lowering!