76
TruVision Series 7 IP Camera Configuration Manual
Send Email
Send an email to a specified address when there is a motion detection
alarm.
Note:
You must configure email settings before enabling this option.
See “To set up the email parameters” on page 42 for further
information. If you want to send the event snapshot together with the
email, select the
Attached Snapshot
option.
Notify Alarm Recipient
Send an exception or alarm signal to remote management software
when an event occurs.
Upload to FTP/Memory
Card/NAS
Capture the image when an alarm is triggered and upload the picture
to NAS, Memory Card or FTP server.
Note
: To upload the snapshot to NAS, you must first configure the
NAS settings. See ““NAS” on page 93 for further information.
To upload the snapshot to an FTP, you must first configure the FTP
settings. See “To define the FTP parameters” on page 41 for further
information. Enable the
Upload Type
option.
To upload the snapshot to FTP and NAS when motion detection or an
alarm input is triggered, you must also select
Enable Event-triggered
Snapsho
t
under the snapshot parameters. See “Scheduled snapshot”
on page 89 for further information.
Trigger Alarm Output
Trigger external alarm outputs when an event occurs. Select “Select
All” or each individual alarm output.
Note:
This option is only supported by cameras that support alarm
output.
Trigger Recording
Triggers the recording to start in the camera.
7. Click
Save
to save changes.
Intrusion detection
You can set up an area in the surveillance scene to detect when intrusion occurs. Up to
four intrusion detection areas are supported. If someone enters the area, a set of alarm
actions can be triggered.
To set up intrusion detection:
1. Click
Configuration
>
Event
>
Smart
Event
>
Intrusion Detection
.
