TruVision Series 7 IP Camera Configuration Manual
67
2. Select the
Enable
box to enable this detection of event.
3. Move the
Sensitivity
slider to set the detection sensitivity.
4. Edit the arming schedule for video tampering. The arming schedule configuration is
the same as that for motion detection. See “To set up motion detection” on page 62
for more information.
5. Specify the actions when an event occurs. Select one or more response actions
when a video tampering is triggered.
Send Email
Send an email to a specified address when there is a motion
detection alarm.
Note:
You must configure email settings before enabling this
option. See “To set up the email parameters” on page 42 for
further information. If you want to send the event snapshot
together with the email, check the
Attached Snapshot
option.
Notify Alarm Recipient
Send an exception or alarm signal to remote management
software when an event occurs.
Trigger Alarm Output
Trigger external alarm outputs when an event occurs. Check
“Select All” or each individual alarm output.
Note:
This option is only supported by cameras that support
alarm output.
6. Click
Save
to save changes.
