1
Underside of machine frame
2
Set screw
3
Adjustable leg
Fig. 69528
5. At the front of the machine, fully unscrew the set screws of
the adjustable legs about 30mm out of the machine body
and glue with Loctite.
▶
Allen key, AF 8
6. At the front of the machine, position the adjustable legs
under the set screws.
7. At the rear of the machine, guide the adjustable legs into
the drop-in anchors and align them.
8. Remove the wooden beams and carefully lower the machine
onto the adjustable legs.
9. Screw the nuts (2 x M16) and plain washer loosely onto the
rear anchor.
▶
Do not tighten because the machine must first be set up
and aligned by a TRUMPF service engineer.
▶
Tightening nuts on the rear anchors is performed by a
TRUMPF service engineer.
10. Align the base plates of the adjustable legs parallel to the
machine body.
▶
Do not remove any transport devices!
▶
Transport devices are painted orange and will be removed
by the TRUMPF service engineer.
2
‐
40
Set-up and positioning - Version 1
B1161en
