No external damage to packaging, contents dam-
aged.
Photograph the damage.
Report the damage to TROX immediately in writing.
Note that shipping damage must be reported within
four days of delivery.
Explosion protection
WARNING!
Risk of explosion from parts damaged while in
transit!
Goods damaged while in transit are unsuitable for
use in potentially explosive atmospheres.
–
If upon delivery any damage is visible, inform the
manufacturer. Do not commission the unit.
If upon delivery any damage is visible, inform the
manufacturer. Do not commission the unit.
If upon delivery any damage is visible, inform the
manufacturer. Do not commission the unit.
If upon delivery any damage is visible, inform the
manufacturer. Do not commission the unit.
Failure to comply with these safety notes may lead to
an explosion.
3.3 Moving packages
3.3.1 Safety notes regarding transport
Explosion protection
WARNING!
Risk of explosion!
Ignition sources, such as sparks, open flames or hot
surfaces, can lead to explosions in an area with
potentially explosive atmospheres.
–
Only specially trained personnel must carry out
work in an area with potentially explosive atmos-
pheres.
–
Get written permission before you start working
in an area with potentially explosive atmos-
pheres.
–
If you have to carry out work, either ensure that
there is no potentially explosive atmosphere, or
at least avoid any source of ignition. If you have
to work in a zone with potentially explosive
atmospheres, use only equipment that has been
approved for use in that particular zone.
Failure to comply with these safety notes may lead to
an explosion.
Improper transport equipment
WARNING!
Risk to life from using improper transport equip-
ment!
If packages are lifted without adequate transport
equipment and if they are not properly secured, they
may fall off and lead to fatal injuries.
–
Move components only in the position in which
they are to be installed.
–
Stand clear of suspended loads.
–
Do not move additional loads on top of a
package.
–
Use only the intended lashing points.
–
Make sure that no load is imposed on pipes,
ducts or cables.
–
Use only approved lifting gear and slings that are
suitable and sufficient for the load to be carried.
–
Do not tie ropes and chains or make knots or
place them on sharp edges.
–
Use lifting equipment only to lift packages or
units, not to push or pull them.
–
Ensure that ropes, belts and chains do not twist.
–
Ensure that transport equipment has been cor-
rectly assembled, fastened and secured before
you use it to lift anything.
–
Secure all doors, dampers and panels.
–
Move packages without any jerky movements
and put them down when you leave your work-
place.
–
Lifting eyes are designed for one-time use only
and not for permanently suspending loads.
–
Transport tubes are designed for one-time use
only and not for permanently suspending loads.
2.4 ‘Residual risks’ on page 9
Transport and storage
Moving packages > Safety notes regarding transport
Air handling unit X-CUBE Ex
13
