Trox Technik X-CUBE compact, Transport And Installation Manual

Page: 20 / 144

Setting up AHU casing units
Personnel:

HVAC technician
Protective equipment:

Industrial safety helmet

Safety shoes

Protective gloves
Slide plates (Fig. 10/3) considerably simplify the
process of positioning the AHU casing units (Fig. 10/1)
on a surface with a high friction coefficient, such as
rubber or elastomer sheets (Fig. 10/4).
The arrangement of the AHU casing units is given in
the order-specific approval drawing.
Fig. 10: Unit arrangement with anti vibration elements
1.
The rubber or elastomer sheets are com-
pressed to a greater or lesser degree
depending on the weight of each AHU casing
unit. Be sure to adjust any resulting height dif-
ferences.
Position the slide plates (Fig. 10/3, by others)
under the base frames (Fig. 10/2) of the AHU
casing units (Fig. 10/1).
2.
For outdoor installation: Ensure that there is
still enough space to attach the self-adhesive
seal, see
Ä
‘Additional assembly steps for out-
door units’ on page 21.
Move the AHU casing units as close together as
possible.
Fig. 11: Aligning AHU casing units
3. Align the AHU casing units such that they are
flush with one another (Fig. 11/1).
Setting up units with a base frame
Fig. 12: Attaching a ratchet strap
1. Attach a ratchet strap to the base frames of two
AHU casing units (Fig. 12).
2. Tighten the ratchet strap.
ð
The AHU casing units come closer together as
you tighten the strap around the base frames.
4.4.2 Before assembly
Before assembly

Remove all transport tubes and transport protection
devices from the AHU casing units.

Have all the required tools ready.

Have all the applicable documents at hand.

Remove all separately supplied materials and
accessories from the AHU casing units.
Compressed seals will recover fully to their original
state about 60 minutes after the transport protection
devices have been removed.
Setup and assembly
Setting up and assembling the air handling unit > Before assembly
Air handling unit X-CUBE compact 20