Trox Technik X-CUBE compact, Transport And Installation Manual, Page: 11 / 144

3.3 Moving packages
3.3.1 Safety notes regarding transport
Improper transport equipment
WARNING!
Risk to life from using improper transport equip-
ment!
If packages are lifted without adequate transport
equipment and if they are not properly secured, they
may fall off and lead to fatal injuries.
– Move components only in the position in which
they are to be installed.
– Stand clear of suspended loads.
– Do not move additional loads on top of a
package.
– Use only the intended lashing points.
– Make sure that no load is imposed on pipes,
ducts or cables.
– Use only approved lifting gear and slings that are
suitable and sufficient for the load to be carried.
– Do not tie ropes and chains or make knots or
place them on sharp edges.
– Use lifting equipment only to lift packages or
units, not to push or pull them.
– Ensure that ropes, belts and chains do not twist.
– Ensure that transport equipment has been cor-
rectly assembled, fastened and secured before
you use it to lift anything.
– Secure all doors, dampers and panels.
– Move packages without any jerky movements
and put them down when you leave your work-
place.
– Lifting eyes are designed for one-time use only
and not for permanently suspending loads.
– Transport tubes are designed for one-time use
only and not for permanently suspending loads.
Unbalanced loads and centre of gravity
WARNING!
Risk of injury from falling or toppling loads!
Loads may be unbalanced, i.e. the centre of gravity
may not be obvious. If the load is not properly
attached to the lifting equipment, it may topple and
fall. Falling or toppling loads can cause serious inju-
ries.
– Note that the centre of gravity is marked on each
package.
– When you use a crane to move loads, ensure
that the centre of gravity of the load is directly
beneath the crane hook.
– Lift any load carefully and keep an eye on it to
see whether it will stay in place. If required,
change the lashing point(s).
Sticker indicating the centre of gravity
Fig. 4: Shipping stickers
Stickers on the packaging indicate the centre of gravity
(Fig. 4).
Sharp edges, sharp corners and thin sheet metal
parts
CAUTION!
Danger of injury from sharp edges, sharp cor-
ners and thin sheet metal parts!
Sharp edges, sharp corners and thin sheet metal
parts of the heat exchanger or of the cooling or
heating coil may cause cuts or grazes.
– Be careful when working on these components.
– Wear protective gloves, safety shoes and a hard
hat.
Transport and storage
Moving packages > Safety notes regarding transport
Air handling unit X-CUBE compact 11