User Manual Qiwi Lite
Support: www.tronteq.de/support
Release 11/2016
Seite 13 von 31
6.
Settings of the system
6.1.
Ethernet-Ports
The setting of the Ethernet ports is carried out in the web interface under
Configuration > Interfaces
.
The page contains two tables. The top shows the state of the interfaces. The table below can be used
to change the settings.
For each port following settings can be choose:
Option
Value
Description
Name
name of the interface (max. 64 characters, no semicolon, no new
line)
Description
description of the interface (max. 64 characters, no semicolon, no
new line)
Link
enable
port activated
disable
port deactivated
Speed
100 MBit
port set to 100 MBit
10 Mbit
port set to 10 MBit
auto
port uses auto-negotiation
Duplex
full
port uses full duplex
half
port uses half full duplex
auto
port uses auto-negotiation
QoS
Port
All incoming packets of the configured port are prioritized.
Tag
Only packets with TOS (type of service) or PCP (priority code point)
higher than 3 are prioritized.
With “Link Status” ports can be activated or shut down.
Deactivating of unneeded ports is recommended if a link-down event
should be monitored (see section 7.2).
