Trojan Technologies Aquafine TrojanUVLogic Series, Installation & Operation Manual

Page: 85 / 186

Mechanical Wiping Systems (Optional)
Trojan UV Logic
TM
Operations & Maintenance
May 25, 2004
5-7
Stop Plate Bushing Replacement
1. Remove Gear Motor, following Gear Motor
Removal procedure earlier in this chapter.
2. Remove lamps as per the Lamp
Inspection/Replacement procedure found in
Chapter 4, UV Reactor (UVR ).
3. Remove the Wiper Assembly as per the
Sleeve Holder / Wiper Assembly Removal
procedure found in Chapter 4, UV Reactor
(UVR ).
4. Remove the Cotter Pin from the end of Drive
Screw.
5. Remove the Stainless Steel Washer.
6. Option 1: Remove the Sleeves as per the
Sleeve Replacement procedure found in
Chapter 4, UV Reactor (UVR ).
Option 2: Leave the Quartz Sleeves in the
Wiper Assembly and remove the Wiper
Assembly as per the
Sleeve Holder / Wiper
Assembly Removal procedure found in
Chapter 4, UV Reactor (UVR ).
7. Slide the Stop Plate Assembly off the end of
the Sleeves and Drive Screw end
8. Remove Sleeve Bushing by pressing against
the small end while supporting Stop Plate.
9. Insert replacement bushings noting proper
positioning in relation to the Stop Plate.
10. Reassemble the Stop Plate in the reverse
order.
CAUTION
The Sleeves may be left in the
Wiper Assembly when the Stop
Plate is removed, however, if the
Sleeves are not removed, you
must ensure they are properly
supported when the Stop Plate
is not there to avoid damage.
CAUTION
It is essential that the
components of the Stop Plate
Assembly be properly installed
on to the end of the Drive Screw
for consistent wiper operation.
Failure to do so may result in
improper wiper operation.
Flange
Bushing Drive
Screw
Elastomer
Spring
Sleeve
Bushing
Stainless
Washer
Stop
Plate
Stainless
Washer Stainless
Washer
Flange
Bushing
Cotter
Pin