Trojan Technologies Aquafine TrojanUVLogic Series, Installation & Operation Manual

Page: 161 / 186

I nstallation Instructions
TROJAN UV Logic
TM
Operations & Maintenance
May 25, 2004
9-1
INLET
OUTLET
0.8 m CLEARANCE FOR
LAMP
REPLACEMENT
UV SENSOR PORT
9 INSTALLATION
INSTRUCTIONS
9.1 Overview
All Aquafine Corporation products are carefully
inspected and tested before shipment from our
plant. Upon delivery, check the packaging and
equipment for damage incurred during shipment.
9.2 Shipping Contents
The system consists of two major components,
the UVR chamber and the Control Panel (CP).
The components are disconnected at the UV
Reactor (UVR) chamber for shipment.
9.3 Set-up
1. Support connecting pipes to UV system to
avoid any undue strain on the unit.
2. Avoid vibration from close proximity to heavy
equipment or from erratic pumps. Vibrations
from other equipment and/ or water
hammering can cause damage to lamps
within the UVR.
3. Allow sufficient service access clearance for
the unit. Also when preparing the site for
installation allow for Valves, Drain and
Bypass as part of your plumbing circuit.
4. When mounting the CP on the wall, ensure
there is at least a 15-cm (6in) air space
around the sides of the panel for sufficient
cooling of the inner electronic components.
The more air space there is around the
control panel the more efficient the cooling
will be. You will need gaskets. While larger
units have welded on Mounting brackets,
smaller units have the option of having
Mounting Brackets provided. Appropriate
hardware for the mounting brackets, and to
attach the UVR to the piping system is not
provided. See the Layout drawing applicable
to your system in Appendix C.
CAUTION
Installation and maintenance to
be performed by qualified
personnel only.
CAUTION
Regular testing of system
performance using standardized
methods (e.g., water supply
regulations of various countries)
is recommended. When
installing the TrojanUVLOGIC
TM
system, allow enough room for
sampling points
CAUTION
If your system runs with pulse
compression, a buffer tank or
other remedial measure must be
provided.