Trojan Technologies Aquafine TrojanUVLogic Series, Installation & Operation Manual

Page: 100 / 186

UV Sensor
Trojan UV Logic
M
Operations & Maintenance
May 25, 2004
6-2
4. Remove the Nut by turning it counter-
clockwise.
5. Gently remove the UV Sensor from the UV
Sensor port.
6. To re-install the UV Sensor follow steps in
the reverse order. Tighten the Nut until snug.
Do not over torque.(40in·lb)
UV Sensor Replacement
When replacing the UV Sensor, unscrew the old
UV Sensor from the 4 pin male connector and
reattach it to the new UV Sensor.
CAUTION
De-Pressurize & Drain the
UVR.
Pressure must be relieved
from the system prior to any
maintenance, to prevent
damage to the equipment or
personal injury.
CAUTION
Acids used to clean the
sensor can cause burns.
Wear protective clothing
and eyewear when handling
these materials. After
cleaning, rinse the system
components thoroughly with
distilled water. Always follow
the safety precautions
recommended by the
manufacturer of the cleaning
solution.