Trojan Technologies Aquafine TrojanUVLogic Series, Installation & Operation Manual

Page: 61 / 186

UV Reactor (UVR)
Trojan UV Logic
TM
Operations & Maintenance
May 25, 2004
4-3
Power is provided to each UVR from the
corresponding Control Panel (CP). Each UVR
must be wired together with its CP. Please see
the section on the CP for more details.
Specifications
Maximum Operating Pressure: 150 psi (10 Bar)
Material: 316L SST Chamber
Inlet/Outlet Flange requirements: DIN / ANSI /
Sanitary (Up to and including 20cm diameter
chambers.)
Drain Connection: NPT or BSP 1/2in or 1-1/4in
(depending on unit provided.)
Maintenance
Minimal UVR maintenance is required. Follow
the schedule for
TrojanUVLogic
TM
Maintenance
Requirements, found in the Preface to ensure
that:
•
There is no leaking around the UVR .
•
There are no loose fittings or bolts on
flanges.
In addition, during any maintenance being
completed on the UV system, the operator
should wipe clean the UVR of anything that may
have come in contact with it. Mild soap and
water should be used.
4.2 End Caps
Description
There are different End Caps depending on
system features and types. All Short & Long
Lamp models come with End Caps. The
purpose of the End Caps is to help protect the
equipment against accidental damage. Models
that come with Automatic Wiping have longer
End Caps, while models that come with no
wiping, or mechanical wiping have shorter End
Caps.
Specifications
Material: Painted Aluminum or Plastic depending
on model.
Maintenance
End Cap Removal & Installation
Note:
Midflow Models are not supplied with
End Caps.
For Bolt-On Flange Style End Plates (20+cm
Diameter Models)
1. Remove the two Philip screws from the End
Cap.
2. Pull the End Cap Straight out and away from
the End Plate.
3. Complete the required Maintenance.
4. Line the End Cap up with the Conduit
Support Bracket and push the End Cap over
the End Plate until it sits flush against the
UVR Flange.
CAUTION
To avoid personal injury, turn off
power before removing UVR
End Cap.
End Cap Mounting
Hardware
End Cap
End Cap Mounting
Bracket