www.trikdis.com
26
February, 2020
“Ethernet” communicator
E16
iO expander settings window
Expander
iO
has: terminals for 1 input, 1 output (relay contacts) and 1-Wire serial bus for connecting temperature sensors.
Relay output can be controlled according to logical (AND, OR, XOR) conditions.
Input IN1 type
– set the input type (NO or NC).
Max
◦
C(T1)
– when the temperature is higher than this setting, an event message will be generated. For an event message
to be generated, it must be enabled in the table.
Min
◦
C(T2)
– when the temperature is lower than this setting, an event message will be generated. For an event
message to be generated, it must be enabled in the table.
Relay control
– set logical (AND, OR, XOR) conditions, upon which the relay output will be controlled.
In the table inputs can be assigned Contact ID event and restore codes. After an input is triggered, the communicator will send
an event with the set event code to the monitoring station receiver and to
Protegus
app. Set as described in the previous page
about
iO-8 expander settings window
.
6.8
“Event summary” window
This window allows you to turn on, off, and modify internal messages sent by your device. Disabling an internal message in this
window will prevent it from being sent regardless of other settings.
COMMUNICATION
– message about connection error between the control panel and
E16
.
POWER
– message about low power supply voltage.
REMOTE_STARTED
– message about remote connection to configure
E16
with
TrikdisConfig
.
REMOTE_FINISHED
– message about disconnection from remote configuration with
TrikdisConfig
.
