Tridonic DALI MSensor 02, Product Manual

Page: 19 / 38

&nbsp Presence control
Documentation DALI MSensor 02 | 02-2012 | en - 19 / 38 -
1
Fade-in
time
The time needed to reach the presence value.
A
Presence
value
The value that the luminaire group assumes while a person is present in the room.
2
run-on
time
The time that starts to run after the last motion is detected in a room and after which, when it elapses, the
fade-down time is started. If another movement is detected in the room during the delay time, the delay
time is restarted.
3
Fade time
Time in which the lighting is faded down to the absence value.
4
Switch-off
delay
The time for which the absence value is maintained if no motion is detected.
B
Absence
value
The value that the luminaire group assumes during the switch-off delay.
5
Fade-off
time
The time needed to dim down from the absence value.
Notice
If the motion sensor is switched off manually during operation, it is temporarily deactivated. The duration of
deactivation depends on the value of the "Dead time (manual OFF)" parameter. If the sensor detects motion
during the time lag, it restarts the time lag afresh. The motion sensor is reactivated when the time lag has
elapsed.
Commissioning
Setting the operating mode
The individual operating modes can be set in the masterCONFIGURATOR software (V2.02 or later) ( see chapter "Source
). directory", page 35
Setting the profile
The individual profiles can be set in the masterCONFIGURATOR software (V2.02 or later) ( see chapter "Source directory",
). page 35
Setting the "Dead time (manual OFF)"
The value of "Dead time (manual OFF)" can be set in the masterCONFIGURATOR software (V2.02 or later) ( see chapter
"Source directory", page 35
Enhanced functionality
DALI MSensors 02 of different DALI groups can synchronise their motion detection, i.e. a DALI MSensor 02 can monitor
other DALI groups with DALI MSensors 02 and respond appropriately to the "Motion detected" synchronisation command in
another group. A DALI MSensor 02 can monitor up to 4 other DALI groups.
The following parameters can be adjusted:
Go to
Presence
value
The "Motion detected" synchronisation command is interpreted in the same way as if the actual sensor
detected motion.