TriboServ FlexxPump1, Original User Manual

Page: 24 / 54

Revision: 0
FlexxPump1 B
User Manual
24 EN-
6.3.1 LCD
For optical output, information in the various states is displayed on the LCD via FP1
B. You will be supported by three coloured LEDs to the right of the LCD, depending on
the state of the FP1 B. This allows you to assess the condition of the FP1 B from a di-
stance; the following applies: green: OK; red: Error. The following tables show the LED
assignment on the LCD as well as the explanation of the respective output:
LCD Description Naming Detail
chapter
The red LED only lights up if the-
re is an error. The FP1 B must be
ON before the error occurs.
Error with
the FP1 B
6.4
The yellow LED only lights up if
the activation and programming
key has touched the action surfa-
ce (activation and programming
key detected).
Activation
and pro-
gramming
key detected
by FP1 B
6.3
The green LED lights up during
a dispensing process for approx.
10...18 seconds.
FP1 B
dispenses
lubricant
6.3
The green LED lights up when
changes are possible and the
activation and programming key
was previously detected.
Changes
possible
6.3
The green LED flashes every 30
seconds when FP1 B is ON and
there is no error.
FP1 B is
ready for
use
6.3
The green LED flashes 2x when
a value has been confirmed. In
addition to the green LED, the
LCD also flashes 2x.
Acceptance
of changed
value
6.3
Assignment (graphic) Assignment (in words)
upper LED: red
medially LED: yellow
lower LED:
green