TriboServ FlexxPump1, Original User Manual

Page: 41 / 54

Revision: 0
FlexxPump1 B
User Manual
41 EN-
The microelectronics integrated in the FP1 B permanently monitors the status. In the
event of irregularities, an addressed error message is displayed on the LCD. The red
LED flashes every 5 seconds and also signals an error optically.
LCD Name Description Remedy
Error
E1
Cartridge Error;
Cartridge not
recognized or
corrently not
mounted

Place a new cartridge on FP1
B (see chapter 7.2).

No confirmation of the error
necessary; it is automatically
cleared after the remedial
action.
Error
E1
Cartridge
(Symbol) empty

Place a new cartridge on FP1
B (see chapter 7.2).

No confirmation of the error
necessary; it is automatically
cleared after the remedial
action.
Error
E2
Overload; the
back pressure
at the lubricati-
on point is too
high.

Check the lubrication point
and eliminate the cause of the
fault.

Switch FP1 B off (OFF) and
on (ON) again.
Error
E3
Battery empty

Switch FP1 B off (OFF).

Replace the battery together
with the cartridge (see chapter
7.2).

Switch FP1 B on (ON).
E1
E2
E3
E1
6.4 Error codes

The FIL-Menu can only be reached from the ON mode (FP1 B switched on). When
you enter the FIL-Menu, you will return to the ON mode, even if you cancel FIL prema-
turely with CLR.