TriboServ FlexxPump1, Original User Manual

Page: 39 / 54

Revision: 0
FlexxPump1 B
User Manual
39 EN-
on the action surface; the other values of the emptying time Et run through one after
the other. However, you can also remove the activation and programming key from the
action area and bring it back to the action area shortly afterwards to reach each value
one after the other. If the final value of the emptying time Et of Et=24 is reached and no
value has been selected, the menu returns to Et=01 and the cycle can be restarted.

As long as the new value you choose for the emptying time Et (Et
new
) is displayed in
the LCD, remove the activation and programming key from the action area.
Ü
The yellow LED disappears, the green LED and the LCD flash 2x. The selected new
value (Et
new
= Et
is
) of the dispensing time h has now been accepted.
No changing of the value of the emptying time Et:

If you do not want to change the value of the emptying time Et, the activation and
programming key must remain removed from the action area immediately after entering
the PRO-Menu.
Ü
The LCD as well as the green LED flashes twice and the emptying time Et is display -
ed in the LCD.

Insert the activation and programming key into the hole provided on the underside of
the FP1 B.

The PRO-Menu can only be reached from the ON mode (FP1 B switched on).
When you enter the PRO-Menu, you will return to the ON mode.

If you have made changes to the values of the emptying time Et in the PRO-Menu
and the FP1 B is otherwise ready for operation (battery full and inserted as well as a
cartridge fitted), the FP1 B will immediately start with the calculated waiting time until
the next dispensing.

Observe the back pressure values displayed on the LCD if they are of interest to
you.

During the dispensing process, the green LED lights up; in addition, the counterpres-
sure for the stroke is displayed in the LCD.
The parameters that can be set for the emptying time Et and their respective permissib-
le values are specified as follows:
Et := Emptying time of a full cartridge in months (Et).
The emptying time can be set between 1 | 2 | 3 | ... | 24 months.
The time counter integrated in the microelectronics of the FP1 B starts coun-
ting the pause time at the end of a successful and fully completed dispensing
cycle.