© Copyright 2012TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-676APBO
69
WPA-PSK (or WPA2-PSK) :
WPA (or WPA2) Algorithms, allows the system
accessing the network by using the WPA-PSK protected access.
Cipher Suite :
By default, it is
AES
. Select either AES or TKIP cipher suites
Pre-shared Key :
Enter the pre-shared key; the format shall go with the
selected key type.
Group Key Update Period :
By
default, it is
3600
seconds. This time
interval for rekeying GTK, broadcast/multicast encryption keys, in
seconds. Entering the time-length is required.
WPA-Enterprise (or WPA2-Enterprise):
The RADIUS authentication and
encryption will be both enabled if this is selected.
WPA General Settings :
•
Cipher Suite :
By
default, it is AES. Select either AES or TKIP cipher
suites
•
Group Key Update Period :
By
default, it’s
3600
seconds. This time
interval for rekeying GTK, broadcast/multicast encryption keys, in
seconds. Entering the time-length is required.
•
PMK Cache Period :
By default, it's 10 minutes. Set
WPA2
PMKID
cache timeout period, after time out, the cached key will be deleted.
•
Pre-Authentication :
By default, it's “Disable”. To Enable is use to
speed up roaming before pre-authenticating IEEE 802.1X/EAP part of
the full RSN authentication and key handshake before actually
associating with a new AP.
Radius Server Settings :
•
IP Address :
Enter the IP address of the Authentication RADIUS
server.
•
Port :
By default, it’s
1812
.
The port number used to communicate
with RADIUS server.
•
Shared secret :
A secret key used between system and RADIUS
server. Supports
8
to
64
characters.
•
Session Timeout :
The Session timeout is in the range of
0
~
60
seconds
. The default is
0
to
disable re-authenticate service.
Amount of time before a client will be required to re-authenticate.
WEP 802.1X :
When WEP 802.1x Authentication is enabled, please refer to the
following Dynamic WEP and RADIUS settings to complete configuration.
Radius Server Settings :
•
IP Address :
Enter the IP address of the Authentication RADIUS
server.
•
Port :
By default, it’s
1812
.
The port number used to communicate
with RADIUS server.
