© Copyright 2012TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-676APBO
100
PPTP :
The Point-to-Point Tunneling Protocol (PPTP) mode enables the
implementation of secure multi-protocol Virtual Private Networks (VPNs)
through public networks.
IP Address :
The IP address of the WAN port
IP Netmask :
The Subnet mask of the WAN port
PPTP Server IP Address :
The IP address of the PPTP server
User Name :
Enter User Name for PPTP connection
Password :
Enter Password for PPTP connection
Reconnect Mode :
•
Always on
– A connection to Internet is always maintained.
•
On Demand
– A connection to Internet is made as needed.
•
Manual
– Click the “
Connect
” button on “
WAN Information
” in the
Overview page to connect to the Internet.
Idle Time :
Time to last before disconnecting PPPoE session when it is
idle. Enter preferred Idle Time in minutes. Default is “
0
”, indicates
disabled. When Idle time is disabled, the “
Reconnect
Mode
” will turn out
“
Always
on
”
MTU :
By default, it’s
1460
bytes. MTU stands for Maximum Transmission
Unit. Consult with WISP for a correct MTU setting.
MPPE Encryption :
Microsoft Point-to-Point Encryption (MPPE) encrypts
data in Point-to-Point Protocol(PPP)-based dial-up connections or Point-
to-Point Tunneling Protocol (PPTP) virtual private network (VPN)
connections.
128
-
bit
key (strong) and
40
-
bit
key (standard) MPPE
encryption schemes are supported. MPPE provides data security for the
PPTP connection that is between the VPN client and the VPN server.
DNS :
Check “No Default DNS Server” or “Specify DNS Server IP” radial button as
desired to set up system DNS.
Primary :
The IP address of the primary DNS server.
Secondary :
The IP address of the secondary DNS server.
MAC Clone :
The MAC address is a 12-digit HEX code uniquely assigned to hardware
as identification. Some ISPs require you to register a MAC address in order to access
to Internet. If not, you could use default MAC or clone MAC from a PC.
Keep Default MAC Address :
Keep the default MAC address of WAN port on
the system.
Clone MAC Address :
If you want to clone the MAC address of the PC, then
click the
Clone MAC Address
button. The system will automatically detect your
PC's MAC address.
Manual MAC Address :
Enter the MAC address registered with your ISP.
Click
Save
button to save your changes. Click
Reboot
button to activate your changes
