Chapter 1: Working with the ER-1000
TR0190 Rev. B1
10
Interface
Description
AP radio port
N-type antenna connector for access point radio
Ethernet
10/100 Mbit Ethernet interface
Passive PoE
PoE power input (9-28VDC, 12W)
Not compatible with IEEE 802.3af
Table 2. EL-500 Interfaces
1.3.1
Ethernet and PoE
The EL-500 has a 10/100 Ethernet port that supports passive Power over Ethernet (PoE). The
PoE power injector should supply an input voltage between 9-28VDC and a minimum of 12W.
The pinout for the Ethernet interface on the EL-500 is provided in Table 3.
The EL-500 is equipped with an auto-sensing Ethernet port that allows both regular
and cross-over cables to be used to connect to it.
Pin
Signal
Standard Wire Color
1
Tx+
White/Orange
2
Tx-
Orange
3
Rx+
White/Green
4
PoE V+
Blue
5
PoE V+
White/Blue
6
Rx-
Green
7
Gnd
White/Brown
8
Gnd
Brown
Table 3. Ethernet port pinout
To power the EL-500, connect an Ethernet cable from the Ethernet port of the EL-500 to the
port labeled “CPE” on the supplied PoE injector and apply power to the PoE injector using the
supplied power supply
Summary of Contents for EL-500
Page 20: ...Chapter 3 Using the Web Interface TR0190 Rev B1 20 Figure 8 Rebooting the EL 500...
Page 68: ...Chapter 11 Ethernet Interface Configuration TR0190 Rev B1 68 Figure 38 Wired DHCP settings...
Page 108: ...Chapter 16 Controlling Access to the ER 1000 TR0190 Rev B1 108 Figure 50 VAP ACL configuration...
