Transtech MSE 100.1-EU L, Instruction Manual, Page: 132 / 178

132 Settings
26.7.2 Pad blower
By pressing the push button
B
the signal for the Pad blower can be activated or deacti-
vated at an automation interface output.
The characteristics of the signal are described in Chapter
31 "Automation Interface" on
page 161 .
The numeric values can be used to set the positions, from
C
to
D
, between which the
signal should be emitted.
The printer positions can be located in manual mode.
See Chapter
25.3.1 "Jog mode" on page 122 .
26.7.3 Auxiliary functions
Peripheral modules can be controlled via output signals to the automation interface. It is
possible to move workpiece holding fixtures to different positions during the print cycle.
The characteristics of the signal are described in Chapter
31 "Automation Interface" on
page 161 .
The dropdown menu allows three default settings to be chosen from.
Off
No signals are emitted for peripheral modules.
2 Position Fixture
Signals are emitted for a workpiece holding fixture with two positions.
3 Position Fixture
Signals are emitted for a workpiece holding fixture with three positions.
B
C D