4.2 MEMORY ACCUMULATOR
Your scale comes equipped with a handy memory accumulator, which can be used in conjunction
with the piece counting feature. As with a hand-held calculator, the memory accumulator can be
added to, displayed and cleared at anytime.
NOTE:
Make sure the scale is in piece counting mode. If it is not, follow the sampling procedure
found in Section 3.3.6 or the alternative sampling procedure found in Section 4.1.
4.2.1
ACCESSING THE MEMORY ACCUMULATOR
1. Press the UNIT key several times until the M+ annunciator becomes lit.
4.2.2
ADDING TO THE MEMORY ACCUMULATOR
1. Press the SAMPLE key. The scale adds the current number of pieces to the memory
accumulator, briefly shows
“-ACC-“
, and then briefly displays the total number of
pieces.
2. Repeat Step 1 as needed – up to 999,999 pieces.
4.2.3
PRINTING THE MEMORY ACCUMULATOR
1. Press the PRINT key.
4.2.4
CLEARING AND EXITING THE MEMORY ACCUMULATOR
1.
Press the CLR key. This will clear the accumulator AND take you out of accumulator
mode.
4.3 CHARGING THE BATTERY
If your scale came equipped with the optional battery pack, follow this procedure to properly charge
your batteries.
NOTE:
You should perform this procedure whenever the scale’s low battery annunciator (BATT)
turns on.
1. Push and hold the ON/OFF key for five seconds, then release or use the power switch to shut
the scale OFF.
2. Locate the battery charger switch on the rear panel of the scale.
NOTE: This may be hidden behind a metal plate held on by two drilled-head screws.
3. Position the switch as shown here:
4. Locate the AC adapter that shipped with the scale.
5. Connect the female end of the AC Adapter to the connector on the rear of scale, and then plug
the adapter into an AC outlet.
Be sure to use the 24 VDC, 2A AC adapter that shipped with
the scale. Any other AC adapter may cause damage to the scale.
6. Allow at least three hours for the batteries to become fully charged. At the end of the charging
period, simply disconnect the AC adapter and resume normal use.
NOTE 1
: The batteries will be charged regardless of the setting of the power switch (ON or OFF). You
may continue to use the scale while the batteries are charging if you wish.
NOTE 2
: After charging the batteries, you may leave the battery charger switch in the position
shown above. If, however, you wish to store or ship the scale, you should position it the opposite
way.
15
