![Transcell Technology TC-2005 Series Setup & Operation Manual Download Page 31](http://html1.mh-extra.com/html/transcell-technology/tc-2005-series/tc-2005-series_setup-and-operation-manual_1150705031.webp)
“z”
- This command is sent to the scale to zero the scale. If the scale is in
motion, the scale will wait until a state of equilibrium is achieved. The
scale will not respond at all if the scale is in positive overload or
negative overload.
“t”
- This command is sent to the scale to tare the scale. If the scale is in
motion, the scale will wait until a state of equilibrium is achieved. The
scale will not respond at all if the scale is in positive overload or
negative overload. The scale will also not respond if it displaying a
negative gross value.
“c”
- This command is sent to the scale to toggle among the configured
units.
TABLE B-1. Recognized Host Commands
NOTE 1
: Host device must send lower case characters to scale.
NOTE 2
: No output for APW or % modes at this time.
Page 31