Page 5-10
5.3.4 RESTORE SYSTEM DEFAULTS SUB-MENU (SysDft)
The Restore System Defaults sub-menu allows you completely restore all configuration
settings throughout the scale to those programmed at the factory. This procedure will not
overwrite your item ID storage.
Use with extreme caution – this process cannot be undone!
To access the Restore System Defaults sub-menu, follow the instructions below.
1. Enter the Service Menu as described above. The scale prompts for the area to setup.
2. Press the SysDft soft key. The scale asks if you wish to restore factory defaults.
3. Press the Yes soft key to restore factory settings or press the No soft key to exit.
4. Press the CLR key twice to return to normal operating mode.
5.3.5 SETUP SUB-MENU (Setup)
The Setup sub-menu allows you to setup both serial ports (if equipped). This sub-menu also
allows you to program the scale to operate in limited feature mode. In limited feature mode,
access to the FUNCTIONS key is locked out during normal operating mode.
To access the Setup sub-menu, follow the instructions below.
1. Enter the Service Menu as described above. The scale prompts for the area to setup.
2. Press the Setup soft key. The sub-menu items are listed above the six soft keys.
5.3.5.1
COM PORT SETUP (COM1 / COM2)
The configuration items for both serial ports (COM1 and COM2) are mostly
identical in content. Table 5-6 lists the items which are available to be configured
for each serial port.
1. Enter the Setup sub-menu as described above.
2. Press the COM1 or COM2 soft key to configure the serial port of your
choosing. The sub-menu items are listed above the six soft keys.
3. Press the soft key pertaining to the parameter you wish to modify. The scale
shows the current status or selection of that item in the form of a highlighted
soft key text.
4. Press the soft key corresponding to the desired status then press the ENT key.
You may exit this screen without making changes by pressing the CLR key.
5. Repeat steps 3 and 4 above until the configuration is complete.
6. Press the CLR key twice to return to normal operating mode.
