Page 2-1
CHAPTER 2: GETTING STARTED
After unpacking the scale, a small amount of preparation is required before the scale can be used.
Please refer to Figure 2-1 below as needed.
0
1
COM 1 Serial Port (RS-232)
Remote Scale Connector
(If equipped)
DC Power Jack
ON/OFF Switch
COM 2 Serial Port (RS-232)
Figure 2-1: DCSG Back Panel
Step 1. Position the scale in its area of intended use. Observe the following guidelines for suitable
location.
1. Choose a firm, stable floor or table.
2. Do not share an AC outlet with electrical noise producing equipment, such as refrigeration
units. This includes products with electrical motors and/or relays.
3. Do not place the scale in an area with changing ambient temperature and/or high humidity.
4. Do not place the scale in an area prone to exposure to direct sunlight, wind, or dust.
5. Do not place the scale in an area with vibrating equipment.
Step 2. Install the AC Adapter.
1.
After placing the scale in its area of use, locate the Model A41408 AC Adapter.
2.
Connect the female end of the AC Adapter to the connector on the rear of scale, and then
plug the adapter into an AC outlet.
Step 3. If applicable, install the serial printer to the COM1 serial port.
1. Connect the printer to the COM1 port using the optional serial cable. See Appendix B for
cabling requirements and pinouts.
2. Configure the communication parameters and select the device type as detailed in Section
5.3.5.
3. Configure the formatting parameters for the printer as detailed in Section 5.2.2.
4. Set the current Time and Date as detailed in Section 5.2.3.
