Trane VarioTrane TR1 2800 Series, Operating Instructions Manual

Page: 19 / 137

004 Active Setup
Value:
Factory Setup (FACTORY SETUP) [0]
Setup 1 (setup 1) [1]
Setup 2 (setup 2) [2]
Setup 3 (setup 3) [3]
Setup 4 (setup 4) [4]
Multi Setup (MULTI SETUP) [5]
Function:
The active parameter Setup is selected here. All pa-
rameters can be programmed in four individual pa-
rameter Setups. Shifts between Setups can be made
in this parameter via a digital input or via serial com-
munication.
Description of choice:
Factory Setup [0] contains the factory-set parameter
values.
Setup 1-4
[1]-[4] are four individual Setups
which can be selected as required. Multi Setup [5] is
used where remote-controlled shifts between the
four Setups via a digital input or via serial communi-
cation is required.
005 Programming Setup
Value:
Factory Setup (FACTORY SETUP) [0]
Setup 1 (setup 1) [1]
Setup 2 (setup 2) [2]
Setup 3 (setup 3) [3]
Setup 4 (setup 4) [4]
Active Setup (ACTIVE SETUP) [5]
Function:
You can select which Setup you want to programme
during operation (applies both via the control panel
and the serial communication port). It is, for example,
possible to programme
Setup 2 [2], while the active
Setup is set to Setup 1 [1] in parameter 004 Active
Setup .
Description of choice:
Factory Setup [0] contains the factory-set data and can
be used as a source of data if the other Setups are to
be reset to a known status.
Setup 1-4 [1]-[4] are indi-
vidual Setups that can be programmed freely during
operation. If
Active Setup [5] is selected, the program-
ming Setup will be equal to parameter 004 Active
Setup .
NOTE:
If data is modified or copied to the active Setup, the
modifications have an immediate effect on the unit's
operation.
006 Setup copying
Value:
No copying (NO COPY) [0]
Copy to Setup 1 from #
(COPY
TO SETUP 1) [1]
Copy to Setup 2 from #
(COPY
TO SETUP 2) [2]
Copy to Setup 3 from #
(COPY
TO SETUP 3) [3]
Copy to Setup 4 from #
(COPY
TO SETUP 4) [4]
Copy to all Setups from # (copy to all) [5]
Function:
You can copy from the selected active Setup in pa-
rameter 005
Programming setup
to the selected Setup
or Setups in this parameter.
NOTE:
Copying is only possible in Stop (motor stopped in
connection with a stop command).
Description of choice:
Copying begins when the required copying function
has been selected and the [OK]/[CHANGE DATA] key
has been pushed. The display indicates when copy-
ing is in progress.
18 TR1 2800 Series VFD
Programming