TRADEDOR TD77DM, Installation Manual

Page: 26 / 44

Tradedor TD77DM & TD77SEL Installation Guide
25
1 Once installation is complete and before powering
up, slide back down dip switch ‘2’ in the control
panel, this can be found on the four dipswitch block
at the bottom middle of the receiver board (usually
blue or red)
(fig. 9.6) .
2 For access to the base rail unit on the right side
(where the writing is), push at the end of the grey
cover and slide to the left. This will give access to
the board
(fig.9.7) .
3 Fix the wireless safety edge to the centre of the
bottom slat of the door on the inside with the safety
edge fitted level and square with the writing the
correct way up.
4 Check to make sure both dip switches are down
in the base rail unit
(fig.9.8A) , these are just off
centre at the top of the unit (usually blue or red).
5 Set the sensitivity on the small dial (fig. 9.8B)
to 3 to start. This can be adjusted for optimum
operation (smaller the number the more sensitive
the unit is, and the dial has to be set on a whole
number).
6 Remove the plastic tab from the batteries and
the LEDs will blink on the safety edge unit.
7 Inside the receiver box press and hold the
“PROG” button on the receiver card (this is the
card plugged onto the board) until you hear
a single beep
(fig. 9.9) , then press and hold
the “PROG” button on the wireless safety edge
(fig. 9.8C) and you will hear another beep from
the receiver box.
8 Wait several seconds until you hear 2 beeps from
the receiver box and pairing is complete.
Programming Base Rail Unit
(SAFETY EDGE)
fig.9.6
fig.9.7
PUSH
GREY
SECTION
12. Setting Up Wireless Safety
Edge Kit
(VELOCITY EDGE)
- TYPE 1