TRADEDOR TD77DM, Installation Manual

Page: 12 / 44

Tradedor TD77DM & TD77SEL Installation Guide
1 Carefully remove the cover by sliding
it upwards from the enclosure, there is
a membrane ribbon from the buttons
on the box to the internal pcb board,
please remove this from the pcb
board by pulling carefully upwards.
2 Drill a 5mm hole in the wall roughly
the centre of where you would like
to fix the receiver box, then using the
supplied fixings insert one of the 6mm
wall plugs into the hole and screw
one of the screws into this leaving
approximately 10mm of screw head
and thread showing.
3 Slide the rear of the receiver box flat
against the wall and over the screw
to hold in place and make sure it is
level and square while you mark the
remaining two fixings located at the
bottom of the receiver box.
4 Remove receiver box from wall and drill
5mm holes into these two marks then
place the remaining 6mm wall plugs
into the holes.
5 Slide the receiver box back over the
top screw and using fixing provided
secure the bottom two lugs in place.
6 Remove the green 4 terminal motor
connector from the board
(fig.5.1)
and you will see the letters on the
board underneath.
7 Run the two core cable from the
safety brake end across to the same
end as the receiver box, making
sure to securely fix the cable out of
the way of the working mechanism
(usually on top of the top box).
fig.5.1
8 Remove the green 4 terminal connector
from the board on left of motor connector
(fig.5.1) you will see letters and symbols
underneath, please remove link wire.
9 Wiring as follows;
Pre wired Mains Power:
N – Neutral / Blue power cable
L – Live / Brown power cable
E – Earth / Green/Yellow power cable
Motor:
E - Green / Yellow motor cable
N - Blue motor cable (4 core)
L - Brown motor cable (4 core)
L - Black motor cable (core)
Safety Brake:
GND – Blue wire from safety brake cable
- Brown safety brake cable
11
5. Installing Reciever Box
(HOLD TO RUN)
- TYPE 1